Cerwin-Vega Professional Audio Mixer CVM-1022 - Manual (Page 17)

17
GENERAL SPECIFICATIONS
*0dB=0.775Vrms, 0dBV=1VRMS
Maximum Output Level
(0.5% T.H.D. at 1kHz)
+20dB (MAIN L/R), +20dB (AUX, EFX, CTRL ROOM)
+20dB (INSERT) more than 100mW (HEADPHONES) @ 33Ω
T.H.D. <0.1% @ +14dB 20Hz~20kHz (MAIN L/R, AUX SEND, EFX SEND, CTRL ROOM)
Frequency Response 20Hz~20kHz, +1/-2dB (MIX L/R, AUX SEND, EFX SEND, CTRL ROOM)
Hum and Noise (Average,
20kHz LPF Rs = 150Ω)
-127dB equivalent input noise, -95dB residual noise (MAIN L/R, AUX/EFX SEND, CTRL
ROOM OUT), -88dB (MAIN L/R, AUX/EFX send, CTRL ROOM OUT)
* Master fader at nominal level and all channel fader Minimum.
Maximum Voltage Gain
66dB MIC IN to MAIN L/R, 60dB MIC IN to AUX, 66dB MIC IN to EFX
76dB MIC IN to CONTROL ROOM L/R, 58.2dB MIC IN to REC L/R, 46dB LINE IN to MAIN L/R
46dB LINE IN to AUX, 46dB LINE IN to EFX
56dB LINE IN to CONTROL ROOM L/R, 36dB ST IN to MAIN L/R
6dB AUX RETURN IN to MAIN L/R, 16dB TAPE IN to MAIN L/R
Crosstalk (at 1kHz) -70dB between input channels, -70dB between input/output channels
Gain Control (mono Input
channel)
44dB Variable (-50dB ~ -6dB), (-30dB ~ +14dB)
Gain Control (mono/stereo
combination Input channel)
40dB Variable (-20dB ~ +20dB)
Input Channel Equalization
HIGH: 12kHz shelving, MID: 2.5kHz peaking, LOW: 80Hz shelving * turnover/roll off
frequencies: located 3dB below maximum boost/cut
LED Meters 10-segment LED x2 MAIN L/R
Channel Indicators
Peak: An indicator for each channel turns on when the pre-channel fader signal is 5dB
below clipping.
Phantom Power +48V DC
Power Source/Power
Consumption
USA/Canada 120VAC / 60Hz / 25W
England/Australia 240VAC / 50Hz / 25W
Korea 220VAC / 60Hz / 25W
Europe 230VAC / 50Hz / 25W
Weight 2.8 kg (6.2 lbs)
Dimension (W x H x D) 249 x 75 x 290 mm (9.8 x 3.0 x 11.4 in)
*Specifications and design subject to change without notice for improvements.