Countax A50 - Manual (Page 3)

Page 26 Page 3
Safety Instructions Notes:
4. Replace faulty silencers.
5. Before using always inspect to see that the blades, bolts and
cutter assembly are not worn or damaged.
6. Check the condition of the tyres and ensure that they are
inflated to the correct pressure (refer to the specifications).
This is particularly important if the machine is to be taken
on the public highway.
7. Check the mower is in good working order, paying
particular attention to brakes and steering.
8. Check that all linkages, connections, and pivot nuts are
secure and that the wheel nuts are torqued correctly.
1. Do not operate the engine in a confined space where
dangerous fumes can collect.
2. Mow only in daylight or in good artificial light.
3. Before starting the engine, disengage blade and attachment
drives and shift into neutral.
4. Take care on slopes of more than 10º incline or decline
(Maximum safe operation is at 15º).
5. Remember that there is no such thing as a ‘safe’ slope.
Travel on grass slopes requires particular care to guard
against overturning:
• Do not stop or start suddenly when going up or downhill.
• Engage clutch slowly. Always keep machine in gear,
especially when travelling downhill.
• Machine speed should be kept low on slopes and in tight
turns.
• Stay alert for humps and hollows and other hidden hazards.
• Avoid mowing across the face of the slope.
6. Watch out for traffic when crossing or near roadways.
7. Stop the blades rotating before crossing surfaces other than
grass.
8. When using the machine, never direct discharge of material
toward bystanders or allow anyone near the machine while
in operation.
9. Never operate the mower with defective guards, shields or
without safety protective devices in place and in good
working order.
10.Do not change governor settings to increase the revs of the
engine. Operating an engine at excessive speed increases
the risk of injury.
11.Before leaving the operators position:
• Disengage the drive to the cutter blades and attachments
and lower the attachments.
• Change to neutral and set the parking brake.
• Stop the engine and remove the ignition key.
12 .Disengage drive to attachments, stop the engine and
disconnect the spark plug lead or remove ignition key
before:
• Clearing blockages.
• Checking, cleaning or working on the mower.
• Refuelling.
• Removing the grass catcher.
• After striking a foreign object. (Inspect the mower for
damage and make repairs before restarting the Tractor).
• If the machine starts to vibrate abnormally check immediately
and call dealer if necessary.
13.Disengage drive to attachments when transporting or not in use.
14.Reduce the throttle setting during engine run-out.
15.Never work on the mower when the engine is running.
1. Check that all nuts, bolts, and screws are tight to be sure the
equipment is in safe working condition.
2. Never store the equipment with petrol in the tank inside a
building where fumes may reach open flame or spark.
3. Allow the engine to cool before storing in any enclosure.
4. To reduce the risk of fire keep the engine, silencer and battery
compartment free of grass, leaves, petrol or excessive grease.
5. Check the grass catcher frequently for wear and tear or
deterioration.
6. Replace worn or damaged parts for safety.
7. If the tank has to be drained, this should be done outdoors.
8. Be careful during adjustments of the machine to prevent
entrapment of the fingers between moving blades and fixed parts
of the machine.
9. Do not use steam cleaners or high pressure washers directly
towards bearings or electrical components (Countax do not
recommend the use of these power cleaners).
SUPPLEMENTARY INSTRUCTIONS FOR USE
OF COUNTAX A20/50 TRACTOR
1. Use good sense at all times and, to ensure this Tractor is safe and
serviceable, fit only original manufacturers’ supplied spares.
2. When inspecting the area to be cut, note also the position of any
stumps, manhole covers, bumps and depressions and avoid them
to prevent damaging the blade.
3. We recommend the use of standard UNLEADED fuel and that
you ensure the fuel tank is full before you start the machine.
4. Always disconnect both battery terminals before attempting any
work in the engine compartment.
5. Do not leave the Tractor unattended and running.
6. Do not put hands near moving belts or the Power Take-Off pulley
while it is rotating.
OPERATION
MAINTENANCE AND STORAGE