8118-fm-i, Installation instructions – Golden Lighting 8118-FM PW User Manual
Page 2
For Customer Service, contact the place of purchase to arrange for replacement parts.
INSTALLATION INSTRUCTIONS
Fixture Name: Alston Place 8118-FM UBS
For Flush Mount Light Fixture
WARNING ! SHUT OFF POWER AT FUSE OR CIRCUIT BREAKER.
HANGING THE FIXTURE (Fig.1)
1.Carefully remove the new fixture from the carton and
the yellow bag that holes all your parts. Check that
all
parts are included as shown in the illustration and
parts
list.
2. Shut off power at the circuit breaker and remove the
old fixture from ceiling, including the old mounting strap.
3. Thread the two Fixture Mounting Screws (G) into
the
pre-drilled Holes in the Mounting Strap (
E
) spaced the
same distance apart as the holes in the ceiling pan.
Secure in place with Hex nuts (F).
4. Attach Mounting Strap (
E
) to the junction box
using
the two Mounting Screws (
D
)
Fig. 1
CONNECTING THE WIRES (Fig 2)
5. Attach the power supply wires to the fixture lead
wires by connecting BLACK to BLACK (or SMOOTH)
and WHITE to WHITE (or RIBBED).
6. Attach the GROUND wire(GREEN or COPPER) from
the Junction Box and the fixture Ground wire to the
green Ground Screw (L) on the Mounting Bracket (E) or
connect both wires together using a wire connector.
NOTE: Twist the wires together in the same direction
you twist the wire connector onto the wires.
7. Tuck these wire connections neatly into the Junction
Box.
Fig. 2
FINISHING THE INSTALLATION
8. Finish mounting the Ceiling Pan (J) by placing it over
the Mounting Strap (E) as shown in Fig. 1. Rotate the
pan until the Mounting Screws (G) protrude through the
“Keyholes” located in the bottom of Ceiling Pan (J).
Using a screwdriver, secure the Ceiling Pan (D) by
screwing Mounting Screws (G) until tight.
9. Install the light bulbs in accordance to the fixture’s
specifications.
10. Install the glass shade according to the assembly
instructions.
Fig. 3
YOUR INSTALLATION IS NOW COMPLETE. RETURN POWER TO THE JUNCTION BOX AND TEST THE FIXTURE.