Golden Lighting 8981-WSC BRI / GRM - Manual (Page 2)

INSTALLATION INSTRUCTIONS
Fixture Name: Echelon 8981-WSC BRI / GRM
For Wall Mount Light Fixture
FINISHING THE INSTALLATION (Fig.3)
9. Place the fixture Back Plate (J) over the nipple (H) and
secure the Back Plate (J) against the wall by threading cap nut
(K) until tight as shown on Fig.1
10. Install the Fabric shade and light bulbs as per the fixture
assembly sheet.
YOUR INSTALLATION IS NOW COMPLETE. RETURN
POWER TO THE JUNCTION BOX AND TEST THE FIXTURE.
Fig. 3
For Customer Service, contact the place of purchase to arrange for replacement parts.
WARNING ! SHUT OFF POWER AT FUSE OR CIRCUIT BREAKER.
HANGING THE FIXTURE (Fig.1)
1. Carefully remove the new fixture from the carton and the
yellow bag that holds all parts. Check that all parts are included
as shown in the illustration and parts list.
2. Shut off power at the circuit breaker and remove old fixture
from wall including the old mounting strap.
3. Thread Nipple (H) into Mounting Strap (D) as shown on
Fig.1.
4. Place Lock Washer (E) over end of Nipple (H) protruding
through Mounting strap (D) and thread Hex Nut (F) onto Nipple
(H) until tight as shown on Fig.1.
5. Attach Mounting Strap (D) assembly to the ceiling junction
box (A) (not provided) using the two Mounting Screws (G).
Tighten screws (G) securely with screw driver.
Fig. 1
CONNECTING THE WIRES (Fig 2)
6. Attach the power supply wires to the fixture lead wires by
connecting BLACK to BLACK (or SMOOTH) and WHITE to
WHITE (or RIBBED).
7. Attach the GROUND wire(GREEN or COPPER) from the
Junction Box and the fixture Ground wire to the green Ground
Screw on the Mounting Bracket (D) or connect both wires
together using the correct size of wire connectors.
NOTE: Twist the wires together in the same direction you twist
the wire connector onto the wires.
8. Tuck these wire connections neatly into the Junction Box.
Fig. 2
K
K
J
J
*in wall