COBY electronic CX-CD377 - Manual (Page 17)

Page 16 Coby Electronics Corporation www.cobyusa.com Page 17
Connections
Speakers
Always connect the speakers before connecting the power supply.
Connect the black wire of the left speaker to the black terminal 
marked “L-” on the rear of the main unit.
Connect the red wire of the left speaker to the red terminal

marked “L+” on the rear of the main unit.
Connect the black wire of the right speaker to the black terminal

marked “R-” on the rear of the main unit.
Connect the red wire of the right speaker to the red terminal

marked “R+” on the rear of the main unit.
Auxiliary (optional)
Use a 3.5mm male-to-male line-in cable to connect the line- 
out or headphone out jack of an audio device to the CX-CD377
Auxiliary Line-In jack.
Power
This unit runs on AC 110V or 220V power.
Make sure that the voltage selector on the bottom of the unit 1.
is set to the proper voltage. If you are unsure which voltage
setting to use, please contact the local retailer from which you
purchased this product.
Plug the power cord into an AC wall socket.
2.
To turn the player on, set the POWER switch to the “On” 3.
position.
GETTING STARTED