Great Planes Top Speed - GPMB1050 - Manual (Page 3)

Keep in mind that it is impossible for us to guide you specifically
as to every possible matter that might come up as you
assemble the model. The fun and challenge is to tackle the
problem, using the instructions and photos for resources, as
well as the assistance and advice of fellow modelers and your
local hobby dealer.
The instructions are the basic guide to assembly. Do not alter
or modify the model. Follow the step-by-step instructions
carefully. Read and obey cautions, warnings and directions on
such items as glues, paints and other materials. These are
often TOXIC to the human body in terms of breathing and/or
touch. Be especially cautious of cyanoacrylate glues (also
known as CA glues) that dry almost instantly and bond with
great strength. They require special care since they can be
extremely dangerous if they get into the eyes or on the human
skin. Keep small children and pets away from all building and
finishing materials. Keep your building area safe and clean.
We’ll try to make your boating experience as enjoyable and
“snag-free” as possible. If you find that your kit has any missing
or defective parts, or if you have any questions about building
or operating this model, please call us at (217) 398-8970 and
we’ll be glad to help. If you have problems with or questions
about any accessory items not included in the parts list
(batteries, chargers, radios, fuel, starting equipment, etc.)
please contact the hobby supplier that sold you those items.
❏
2-channel radio system with two (2) servos*. The radio
system you use must be on a “surface only”
frequency. Watertight servos are recommended, but
not required.
*NOTE: It is recommended one of the servos have
at least 65 Oz. In. of torque for use as the steering
servo.
❏
Waterproof bag for receiver, such as the Kyosho
TR-12 waterproof rubber bag (KYOB6055)
❏ Small bottle of CA* glue (GPMR6007)
❏ Rubbing alcohol
❏
Clear tape
❏
Pro thread locking compound (GPMR6060)
❏
Shoe-Goo (DTXC2460)
❏
6-Minute epoxy (GPMR6045)
❏
Weights (GPMQ4485)
❏
Mixing sticks (GPMR8055)
*NOTE: In several places, the instructions call for the use of
“CA glue.” The glue used in the Top Speed instruction
manual is GREAT PLANES PRO
® CA+ MEDIUM
(GPMR6007) and is available from your local hobby shop).
❏ Electric or hand drill
❏
Drill Bits:1/16" [1.6mm], 5/64" [2mm], 1/8" [ 3mm],
5/32" [ 4mm], 3/16" [ 4.8mm], 1/4" [ 6mm], 7/16" [11mm]
❏
Small screwdrivers (regular and phillips)
❏ Pliers
❏
Sandpaper (180, 320 and 400 grit)
❏
Flat file
❏ Hobby knife
❏
Scissors
❏ Masking tape
❏
Clear tape
❏ Paper towels
TOOLS REQUIRED
ADDITIONAL ITEMS REQUIRED
PRECAUTIONS
WARNING!
This boat is controlled by radio control, which is subject
to possible interference from other R/C transmitters,
paging systems and many other sources of RF or
electrical noise. When operating this boat, allow a “safety
margin” to avoid an accident in the event you experience
a brief loss of control. Before turning your radio on, make
sure no one else in the area is operating a radio on the
same frequency (channel).
WARNING!
Because of the speed and mass of this boat, it is
capable of inflicting property damage and severe
personal injury if a collision occurs. Never run this boat
in the presence of swimmers or where the possibility
of collision with people or property exists.
WARNING!
The engine is very powerful and spins the propeller
with great torque. Read the instructions manual
included with you engine for proper operating
procedures and safety precautions.
SAFETY WARNINGS
3