Haltech F9A - Manual (Page 81)

80
Chapter 2
Using the Software Features
The Output Options Page
The Output Options Page is where all F9A options are enabled/disabled and programmed.
This page may be accessed in either Online or Offline mode. Remember that any changes you
make in Offline mode will not affect the ECU.
Pressing
sR
will take you to the Options Menu. Press
2
to go to the Output Options Page.
Alternatively use the
tR
hot key combination
Here, the five F9A options are shown in five windows. Current settings are displayed for each
of the options. Use the left and right arrow keys to highlight the function you are interested in.
In the case of selecting the Auxiliary Outputs, use
v
to cycle through the functions, and
press
y
to select the one you want. Although any channel may perform any function, each
function may be selected only once. Some options cannot be used together because they use
the same hardware. These are noted in there detailed descriptions in Chapter 16. Other
restrictions apply when using the Advanced Mode. If you are using this mode, consult
Appendix B for details on these restrictions.
To adjust the parameters of the Idle Speed Control or the Closed Loop Control functions, hit
y
when that function is highlighted. In the case of the three Auxiliary Outputs, highlight the
channel, then use the up and down arrows to move through its parameters. Strike
y
if you
wish to make a change. Some functions have maps associated with them, which are accessed
through their Options' windows.
A keystroke guide is available at the bottom of the screen. Further, a simple Help window
may be opened by pressing
s+
. This will describe the function you are currently looking
at, and offer some explanation as to how its parameters are to be used.
Enabling Options
Every option has an Enable flag at the top of its window. Toggling this flag allows you to
switch that option on and off. The settings for an option that is switched off will not change
when you switch it back on later. When a map is loaded from disk, output functions that do
not match what is in the ECU are automatically disabled. After loading a map, return to the
Output Options Page and check the functions you want enabled.
Any change you make in the Options page will not affect the ECU unless you are Online. If
you are making changes Offline, then be sure to save your data to disk so that it may be later
uploaded.