Hk45 & hk45 compact – Heckler&Koch HK45 COMPACT TACTICAL User Manual

Page 16

Advertising
background image

30

31

HK45 & HK45 Compact

Firing the Law Enforcement Modification (LEM) Double-action mode (Hammer

uncocked)

1. Disengage control lever (if applicable) - disengage the control lever by

pressing it downward with the firing thumb so that the "F" on the lever

aligns with the reference line located on the frame.

2. Aim - aim at the target.

3. Remove slack – Remove the slack (free movement of the trigger before

hammer release) before step 4 below.

4. Fire - fire the pistol by pressing the trigger straight the rear with gradually

increasing pressure.

5. Engage control lever – rotate control lever up to place the pistol on safe

once firing is completed.

NOTE: The hammer on HK45 variants 5, 6, & 7 will automatically return to

the uncocked position each time the slide returns to its forward position.

Unloading the Pistol
To unload the pistol, follow the "Clearing" procedure found on page 19.

If the pistol fails to fire, clear and disassemble it and check for:

1. Obstructions in the chamber bore or frame. Remove obstructions.

2. Bad ammunition. Try new ammunition.

3. Unserviceable magazine. Replace magazine.

4. Fouling or lack of lubrication. Clean and lubricate the pistol in accordance

with the instructions contained in this manual.

5. Evidence of severely worn or broken parts.

If your pistol still fails to operate correctly, contact your unit armorer HK

Customer Service at (706) 568-1906.

WARNING: If a cartridge is assembled without powder (a fault of the

manufacturing process), the primer alone may have enough power to propel

the bullet into the bore. A bullet lodged in the bore may cause damage

to the barrel and/or pistol if another cartridge is fired and could cause

personal injury or even death. This event is commonly called a "squib load"

or "pop and no kick" and is characterized by a reduced report and little or

no movement of the slide. An alert operator could notice the occurrence of

this event in time to avoid firing the next cartridge.

Selection and Use of a Holster
When selecting a carrying holster for the HK45, it is important to consider the

following points:

I. The holster must not make contact with or actuate any of the operating

controls. This includes the hammer, slide release, magazine release lever, and

most importantly the control lever and the trigger. The design of the holster

must also not actuate these controls when the pistol is carried in, drawn

from, or returned to the holster.

2. The holster should not cause the slide to move (unlock) when the pistol is

returned to the holster.

3. Accommodations must be provided in the holster for any accessories that

might be present on the pistol.

4. Choose holster designed specifically for the HK45.

Returning the Pistol to the Holster
The HK45 must be made “safe” (or cleared) prior to returning it to the holster.

The pistol is considered safe to return it to the holster when:

1. All fingers are off of the trigger and outside of the trigger guard and;

2. The pistol is "clear" or;

3. The hammer is in the decocked (down) position or;

4. The control lever (if applicable) is engaged in the safe position when the

hammer is cocked.

WARNING: The pistol must never be returned to the holster unless the above

procedures have been completely followed or injury or death could occur.

Storage and Transport

1. Store or transport the pistol and its components clean and lubricated.

2. Store and transport the pistol without cartridges in the chamber, magazine,

or in the storage container.

3. Store and transport the pistol with the slide forward and the hammer down

(uncocked).

4. Clean and lubricate the pistol and it's components at least every twelve (12)

months during storage.

5. Store the pistol and it's components in a clean, dry, dust-free environment

with regulated temperature controls.

6. Store the pistol and ammunition separately under lock and key.

7. LEM variants stored for more than one year should be stored clear with the

weapon dry fired to relieve spring pressure on the internal cocking piece

inside the hammer.

SECTION 5

Advertising
This manual is related to the following products: