Heli-Max HMXE0816 - Manual (Page 6)

6
®
LINKING LINKING
Connecting the AnyLink ™ module or an SLT ™ compatible transmitter to your heli.
1. Turn on the transmitter. Make sure the throttle is at zero.
2. Place the transmitter close to the model.
3. Remove the canopy and locate the small black link button on the PC board.
4. Press and hold the button for 3 seconds.
5. Release and wait 3~5 more seconds. Your system is now ready!
®
BATTERY PRECAUTIONS BATTERY PRECAUTIONS
This Axe 100 FP uses a lithium polymer (LiPo) battery. Follow these precautions
to insure safe and trouble free operation.
● Only use the included charger with the included battery.
● Do not attempt to use this charger with NiCd or NiMH battery packs.
● If the battery should become damaged, discard it. Do not attempt to use
a damaged battery.
● Do not leave the charger unattended while charging. Disconnect the
battery and unplug the charger immediately if either becomes hot!
However, it is normal for the charger to get warm.
● Disconnect the battery from the charger and carefully move the battery
to a fi reproof location if the battery begins to swell or smoke!
● Never trickle charge.
● Never allow the battery temperature to exceed 140° F [60° C].
● Never disassemble or modify pack wiring in any way or puncture cells.
● Do not allow water, moisture or foreign objects into the charger.
● Do not place the charger or any battery on a fl ammable surface or near
a combustible material while in use.
● Do not charge on a carpet, cluttered workbench, paper, plastic, vinyl,
leather, wood, or inside an R/C model.
● Never charge inside a vehicle.
● Always disconnect the battery and remove the charger from the USB
port when not in use.
● Do not attempt to charge a battery if it is swollen or hot.
● Land your model immediately when the battery begins to lose
power. Recharge the battery before attempting another fl ight.
A dangerous situation can occur when attempting to recharge an
over-discharged battery!
● ALWAYS keep a supply of sand accessible when charging.
Dumping sand on the battery will extinguish the LiPo chemical fi re.
● ALWAYS KEEP OUT OF REACH OF CHILDREN.