Heli-Max HMXE08 Manual - Manual (Page 26)

26
PROGRAMMING YOUR TRANSMITTER PROGRAMMING YOUR TRANSMITTER
The Heli-Max TX6024 transmitter is factory set for the Novus UH-1D Huey CX
helicopter. Before making any changes it is recommended to fl y the model
several times. If you feel a change is needed after several fl ights, then please
feel free to make adjustments following the recommendations below.
WARNING! Setting these values incorrectly could result in a loss of
control, damage to the model or possibly injury to yourself or others.
Always make certain that the model is set up correctly before fl ying
the model by checking the control directions and all other settings.
Navigating & Setting Values
Always disconnect the fl ight battery from the e-board before making any
adjustments to the transmitter settings.
Press the [Enter] key to enter programming mode. You will notice that [STICK
MOD 2] is now fl ashing on the display. This is the current item being edited.
Pressing the [UP] key will take you to the previous function and pressing the
[DOWN] key will take you to the next function. Pressing the [EXIT] key will
return you back to the normal operation screen. The [UP], [DOWN] and [EXIT]
keys will not change any values so feel free to navigate the menus using these
three keys.
To make a change use the [L] or [R] keys to select the change and press
[ENTER] to set the value for the function. This is all described in the function list.
Press the [EXIT] key to return to the normal operation screen.