Heli-Max HMXE01 - Manual (Page 2)

Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
Charge the battery. . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
Prepare the transmitter . . . . . . . . . . . . . . . . . . . . . . . . 2
Prepare the helicopter for flight . . . . . . . . . . . . . . . . . 3
Install the helicopter battery . . . . . . . . . . . . . . . . . . . . 4
Find a suitable flying site . . . . . . . . . . . . . . . . . . . . . . 4
Description of controls . . . . . . . . . . . . . . . . . . . . . . . . 4
Preflight . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5
Moving the RotoFly . . . . . . . . . . . . . . . . . . . . . . . . . . . 6
Hovering the RotoFly. . . . . . . . . . . . . . . . . . . . . . . . . . 6
Forward flight . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6
Parts breakout . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7
Parts page . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8
The RotoFly is an outstanding ready-to-fly electric helicopter for
indoor flying and outdoor flying on calm days. Although it is not
difficult to operate this model helicopter, we recommend that
you read this instruction book thoroughly and carefully.You may
also want to ask for assistance from your local model flying club
and/or hobby shop.
WARNING: The RotoFly charger is designed to charge only
the LiPo battery supplied with the RotoFly. Do not attempt to
charge any other batteries with this charger, as doing so
may result in damage to the battery or charger, and may
result in a fire. DO NOT charge the battery while it is
mounted in the helicopter.
❏
1. Plug the battery charger into an AC outlet. The light on the
charger should be green. Note: The charger and the training
gear are shipped in the back side of the foam packing.
❏
2. Plug the battery into the charger. The light on the
charger will turn red. WARNING: Do not leave the battery
unattended while it is charging. If the battery becomes hot
disconnect it immediately.
❏
3. When the light on the charger has turned green again
the battery is ready to use. The first charge should take
about an hour. Subsequent charges may take as long as
two hours, depending on much the battery was used since
its last charge.
❏
1. Install the transmitter antenna by inserting it into the
hole in the top of the transmitter and screwing it into place,
using a clockwise rotation.
PREPARE THE TRANSMITTER
CHARGE THE BATTERY
INTRODUCTION
TABLE OF CONTENTS
2