High Power Astro Series - Manual (Page 4)

Instruction Manual
Important Safeguards
For your protection, please read these safety instructions
completely before installation.
Caution
Please check the Voltage Select Switch to be switched at
adequate position. (AC 110V area please switch to 115, AC
220V area switch to 230)
If there is no Voltage Select switch on the unit, please exam
the specification on the PSU sticker and make sure the voltage
function corresponds to the voltage source of your territory.
Please do not unplug the AC power line when the power
supply is in use, even in a flash quick manner will cause
damage to the components.
Please do not store the power supply in high humid
temperature place, or to be used in such condition.
Warning
Please do not open the PSU cover, High voltages exist in the
power supply. Unless authorized personnel.
High Power warrants its product for use within the product
specification. It is very important for you to check and confirm
the product specification meets your requirements before
use.
Installation
To prevent electrical shocks, please disconnect the power
cord from your existing PSU.
Make sure the I/O switch of the new PSU is at off “O” position.
After install the new PSU into the chassis, connect the Main
power connector to the mother board.
Note: Please refer to your motherboard user guide before
connecting the Main power connector and CPU connector.
Connect the CPU connector to the CPU socket on
motherboard.
Connect the PCI-E connector to the graphic card if needed.
Connect the Peripheral connector to peripheral devices such
as DVD, HDD…etc.
Connect the Floppy disk connector to the floppy drive if any.
Connect the S-ATA connector to the S-ATA HDD if any.
If your PSU is equipped with the modular cable management,
please refer to the instruction sticker attached on the PSU for
the proper cable set.
Make sure all connectors are connected properly and firmly.
Protection function
To save guard the power supply and the system, the High Power
PSU is built in with comprehensive protection functions; Over
Voltage Protection, Under Voltage Protection/Over Current
Protection, Short Circuit Protection, and Over Load
protection/Over Temperature Protection.
Note: The PSU will be shut down if the protect function is
triggered. To restore the PSU back to normal, please either
switches off the I/O then on or unplugs the AC power cord and
plug it again then.
Trouble shooting
If your PC system does not respond, please make following
checks:
1. Make sure the AC power cord is connected firmly and the AC
power switch is turned on.
2. Make sure all DC output connectors are connected in the
right direction and plugged firmly.
3. Check whether there is any short circuit problem or defective
peripherals by unplugging each peripheral device one at a
time.
4. If one of the above mentioned problems occurs, please
remove the fault and wait for 1-2 minutes before you turn on
the PSU again. This is necessary to release the latch condition
of the protection circuit.
5. If the PSU is still unable to power up after above checks,
please contact with your dealer for service.
1 2