HONDA 2008 Accord Sedan - Owner's Manual - Manual (Page 232)

CONTINUED
To erase the codes stored in all three
buttons, press and hold the two
outside buttons until the red
indicator begins to flash, then
release the buttons.
You should erase all three codes
before selling the vehicle.
If you want to retrain a programmed
button for a new device, you do not
have to erase all button memory.
You can replace the existing memory
code using this procedure:
Press and hold the HomeLink
button to be trained until the
HomeLink indicator begins to
flash slowly.
Press and hold the button on
HomeLink for 3 to 4 seconds.
Press the HomeLink button again
for about 1 second. It should
operate the garage door.
Press the training button on the
garage door opener unit until the
indicator next to the button comes
on. The indicator may blink, or
come on and stay on. You then
have approximately 30 seconds to
complete the following steps.
1.
4.
5.
3.
HomeLink Universal Transceiver
Erasing Codes
Retraining a Button
Fe
a
tu
re
s
229
LEARN BUTTON
2008 Accord Sedan
Table Of Contents Main Menu