HONDA 2000 Accord Coupe - Owner's Manual - Manual (Page 86)

HomeLink Universal Transmitter
On EX V-6 model
The HomeLink Universal
Transmitter built into your vehicle
can be programmed to operate
remotely controlled devices around
your home, such as garage doors,
lighting, or home security systems.
It can replace up to three remote
transmitters.
Customer Assistance
If you have problems with training
the HomeLink Universal Transmitter,
or would like information on home
products that can be operated by the
transmitter, call (800) 355-3515. On
the internet, go to
www.homelink.jci.com.
Important Safety Precautions
Always refer to the operating
instructions and safety information
that came with your garage door
opener or other equipment you
intend to operate with the
HomeLink Universal Transmitter.
If you do not have this information,
you should contact the
manufacturer of the equipment.
While training or using the
transmitter, make sure you have a
clear view of the garage door or
gate, and that no one will be injured
by its movement.
General Information
If you are training the transmitter to
operate a garage door or gate, it is
recommended that you unplug the
motor for that device during
training. Repeatedly pressing the
remote control button could burn
out the motor.
The HomeLink transmitter stores
the code in a permanent memory.
There should be no need to retrain
the transmitter if your vehicle's
battery goes dead or is
disconnected.
If your garage door opener was
manufactured before April 1982,
you may not be able to program the
HomeLink Universal Transmitter to
operate it. Garage door openers
manufactured before that date do
not have a safety feature that
causes them to stop and reverse if
an obstacle is detected during
closing, increasing the risk of
injury. If you have questions, call
(800) 355-3515.
Training the Transmitter
Before you can use the HomeLink
Universal Transmitter to operate
devices around your home, it must
"learn" the proper codes. For
example, to train the transmitter to
open and close the garage door:
CONTINUED
Instruments and Controls
Main Menu Table of Contents