IC Realtime PoE switch for Intercom System (IHS1030) - Manual (Page 5)

2. Technical Specifications
For product technical specifications, please see Chart 2- 1.
Model IH-S1030
Voltage 24V AC
Power Standby consumption：0.2 W (under free load);
Consumption Max consumption：45W (under full load)
Work Temp -10℃～55℃
Dimensions 179 x 107 x 30 mm
Weight 300g
Chart 2- 1
3. Connections & Notices
This device is designed to power and route data for Indoor Monitors (IHD-7210, etc). Run
standard CAT5 or CAT6 (straight through) to the designated Monitors. Use the uplink ports to
cascade or connect to your existing network infrastructure. The switch will route traffic to
designated nodes on the network.
1. Connect CAT 5 / 6 runs from the Monitors to each of the available ports (see pg.
1) o Note: Ethernet run lengths max at 328ft.
2. Connect a CAT 5 / 6 run from the port labeled 'Out' to your network infrastructure that will be
hosting other parts of the setup (Outdoor IP Video Cameras, etc).
3. Wire your power supply to the respective terminal ports. Assure you have proper leads to
positive and negative
o Note: 24V AC only!
4. Assure all connections are solid and power wires are terminated well.
5. Plug the power source in and switch the power button to 'On'.
6. A red indicator should turn on letting you know the device is receiving proper power
7. You should now be ready to use the Monitors to talk to your other networked Intercom devices
Notices:

Please use standard power supplies only.



Before you plug in the product, please assure proper wiring is made to the device



Before you plug the product in to a power source, please re-confirm that all wiring
matches the instructions. You may turn on the product and if it works as usual, then the
power indicator and run indicator should sustain.

2