Intek RheoVac 940 - Manual (Page 5)

- 3 -
Figure 2 RheoVac Probe Insertion Recommendation
• Use proper input power — check the power select switch position on the electronics. Select
either 115 Vac or 230 Vac before applying power.
• Check the transducer maximum temperature and pressure ratings — never operate a
transducer at or subject it to temperatures or pressures beyond its specified limits.
. .
WARNING - Never allow live high temperature steam to flow either direction in
the exhauster line where the probe is located.
• Keep moisture out of the enclosures — once all service connections are made, make sure the
enclosure lids are tightly closed and all gaskets are in place. Seal conduit lines at the
instrument.
SECTION 2 — INSTALLATION