SoundMax SM-CSE503 User Manual
Page 4
4
it will be necessary to cut steel, reinstall the cosmetic
n place and use the hole you have previously cut as a
te. This will help to insure proper cutting and a good
mark the locations for the speakers mounting
, remove the panel and drill the screw holes. When
finished you may replace the panel.
After cutting and drilling all holes, inspect the mounting
areas for any metal burrs or rough edges. File any area that
may interfere with the mounting of the speaker.
Clean any metal shavings from the mounting area and
check for areas in which water may enter the speaker cavity.
Treat the area for water protection when necessary.
Securing the speakers
Position the speaker into the mounting hole and re-confirm the correct
mounting location and hole placement.
Screw clips are provided to ensure a snug fit. These should be placed over
the metal surface and line up the hole you have previously drilled with the
screw clip. Place the speaker into the hole, align the holes and proceed to insert
the screws. Be sure to tighten the screws evenly so that it will not warp the
speaker frame.
Turn your system back on and confirm the speakers operation first at a low
volume and then you may increase the volume as you desire.
After installation acoustic system and having tested it the speaker grill will
have to be inserted. Turn on you system and follow these steps carefully:
- locate the speaker grill;
- now carefully inspect the place where the speaker grill will be mounted – there should be no blowholes;
- fix the speaker grill by screws.