Interlogix VTP-H Series - Manual

1 of 9
© 2010 GE Security, Inc.
P/N 1069682 • REV 1.0 • ISS 14APR10
GE
Security
Multi-Channel Passive
Transceiver Hubs Installation
Sheet
Introduction
GE Security Multi-Channel Passive Transceiver Hubs transmit or receive base-
band video signals over unshielded twisted pair (UTP) wires, point-to-point, for
distances up to 750 feet (228 m). They also provide support for the “up the coax”
Pan/Tilt/Zoom (PTZ) control signals.
These passive hubs are 1U in height and can be wall, desk or rack mounted.
They use Category 2-7 twisted pair wires and do not require power. They provide
built-in surge suppression to protect video equipment against damaging voltage
spikes and provide noise immunity to ensure quality images.
The included RJ-45 adapter provides an easy way to connect the passive hubs to
other GE VPD products via Cat-5 cables and RJ-45 connectors. These passive
hubs are bidirectional and support Up-the-Coax Pan/Tilt/Zoom telemetry signals.
Any unused pair of UTP cables can also be used for transporting other telemetry
signals.
The following model numbers are covered in this document:
• GEC-4VPHUB
• GEC-8VPHUB
• GEC-16VPHUB
• GEC-32VPHUB