Interlogix DesignLine Slim Door - Manual (Page 2)

DesignLine Slim Door/Window Sensor
Installation Instructions
2
Battery replacement
When the system indicates the sensor battery is low, replace it
immediately. Use the recommended replacement batteries (see
Specifications ) or contact technical support for more information.
To replace the batteries, do the following:
1.
To remove the sensor cover, press a small flathead screw-
driver into the slot on both sides of the sensor and turn the
screwdriver 90 degrees. This will disengage the clips
holding the cover and base (Figure 1 on page 1).
2. Place a small flathead screwdriver in the slot between the
metal clip and the battery and twist the screwdriver slightly
while holding back one of the black plastic edges holding the
battery. Dispose of the old battery as required by local laws.
3. Insert the replacement battery with the + sign facing out.
4. Verify programming and RF communication with the panel.
See
Verify programming and RF communication on page 1.
External contact
The sensor ships with a six-inch external contact lead. To use the
external contact, open the transmitter, plug in the external contact
header (J1), and connect the brown and blue leads to the external
contact.
Note: The external wire cannot be longer than 3.3 ft. (1 m).
FCC compliance
This device complies with part 15 of the FCC rules. Operation is subject to the
following conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference
that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
FCC ID: B4Z-TX-1010-01
Industry Canada ID: 1175C-TX101001
Specifications
Battery Panasonic 2032, 3 VDC, 225 mAh, lithium
coin battery (5-year typical battery life)
Transmitter frequency 319.508 MHz (crystal controlled)
Transmitter frequency tolerance ± 8 kHz
Transmitter bandwidth
24 kHz
Modulation type Amplitude shift key (ASK)
Unique ID codes 16 million
Peak field strength Typical 30,000 uV/m at 3m
External input sampling current 20 uA
Reed switch magnetic sensitivity 10 to 20 amp turns
Reed sensitivity
0.38-in. (0.97-cm) gap
Magnet type Nd-Fe-B, N45
Magnet dimensions (WxHxD) 1.3 x 0.435 x 0.312 in. (3.3 x 1.1x 0.79 cm)
Supervisory interval 64 minutes
Operating temperature 10 to 120°F (-12 to 49°C)
Enclosure PC-540
Weight 0.55 oz. (15 g)
Dimensions (WxHxD) 1.00 x 2.45 x 0.35 in. (2.54 x 6.22 x 0.89 cm)
Colors White or brown
Technical support
Toll-free: 888.GESECURity (888.437.3287 in the US, including Alaska and Hawaii; Puerto Rico; Canada).
Outside the toll-free area: Contact your local dealer.
www.gesecurity.com