Interlogix TX-6310-01-1 - Manual (Page 7)

Important warning statements
This carbon monoxide alarm is designed to detect carbon
monoxide from ANY source of combustion. It is NOT designed
to detect smoke, fire, or any other gas.
WARNING: Carbon monoxide alarms are not smoke alarms.
This carbon monoxide alarm is not a substitute for installing
and maintaining an appropriate number of smoke alarms in
your home.
This CO alarm will not sense smoke, fire, or any poisonous gas
other than carbon monoxide even though carbon monoxide
can be generated by fire. For this reason you must install
smoke alarms to provide early warning of fire and to protect
you and your family from fire and its related hazards.
Caution: This alarm will only indicate the presence of carbon
monoxide at the sensor. Carbon monoxide may be present in
other areas.
WARNING: This product is intended for use in ordinary indoor
locations of family living units. It is not designed to measure
compliance with Occupational Safety and Health
Administration (OSHA), commercial, or industrial standards. It
is not suitable for installation in hazardous locations as defined
in the National Electric Code.
The installation of this device should not be used as a
substitute for proper installation, use and maintenance of fuel
burning appliances, including appropriate ventilation and
exhaust systems. It does not prevent CO from occurring, nor
can it solve an existing CO problem.
WARNING: This device is designed to protect individuals from
acute effects of carbon monoxide exposure. It may not fully
safeguard individuals with specific medical conditions.
If in doubt, consult a medical practitioner. Individuals with
medical problems may consider using warning devices which
provide audible and visual signals for carbon monoxide
concentrations under 30 PPM.
This carbon monoxide alarm requires a continuous supply of
electrical power - it will not work without power.
This alarm has not been investigated for carbon monoxide
detection below 70 PPM.
Contact information
For servicing or contact information, see interlogix.com.
For residential consumers, please contact your local security
system installation company for product replacement service.
Product returns from security professionals and installers
Before you can return any product to UTC Fire & Security, you
must obtain a return material authorization (RMA). This applies
to all product returns, including warranty repair/replacements,
non-warranty repairs, advance replacements, and credit
returns.
Security Customer Services:
Phone: 888-437-3287
FAX: 503-691-7566
Email: [email protected]
You will need to have the product and following information
ready:
• Original PO number (not required for distribution partners)
• SKU/part number
• Serial number
Manufacturing information
Manufactured by Interlogix, a UTC Fire and Security company,
1275 Red Fox Road, Arden Hills, MN 55112.
P/N 466-2393 • REV A • ISS 14FEB11 7 / 8