Interlogix TVC-5120-1 - Manual (Page 4)

4
Installation
To install the camera:
1. Connect a coaxial cable terminated with BNC
connectors between the VIDEO OUT connector
of the camera and the video in connector on a
monitor, multiplexer, switcher, or other standard
video device.
2. To attach the lens, please refer to the
instructions that came with the lens. See Figure 1
on page 1 for guidance.
Note: If you are using a C-mount lens, screw on
the provided C-mount adapter. For optimal
performance, use an auto iris lens.
3. To connect power, loosen the DC12V and GND
terminal screws on the terminal block using a
screwdriver. Connect a universal 12 VDC power
supply to the terminal block. Retighten the
terminal screws until snug, ensuring that the
power leads are secure. Supply power to the unit
by plugging the power supply into a proper
source.
The power LED illuminates to show that the
camera is receiving power. If it does not
illuminate, check the terminal block connections
and the power source