Interlogix TVB-4105 - Manual (Page 6)

4 TruVision TVB-2104/4104 and TVB-2105/4105 IR Camera User Manual
Figure 3: OSD control cable
A. OSD control pad; B. Power cable; C. Video cable
Table 1: OSD control pad functions
Pad directions Description
Up Zoom-in lens or move the cursor upward to select an item.
Down Zoom-out lens or move the cursor downward to select an item.
Right
Adjust the lens focus to far or move the cursor to the right to select
or adjust the options of the selected item.
Left
Adjust the lens focus to near or move the cursor left to select or
adjust the options of the selected item.
Enter
Press the center of the control pad to display the Main menu. If the
selected item has its own menu, press the control pad to enter a
submenu. Press the control pad for 2 seconds to save all settings
and exit the Main menu.
Installation
Please check the package contents and make sure that the device in the
package is in good condition and all the assembly parts are included.
To install the camera you will need to prepare the mounting surface, mount the
camera, make cable connections, adjust the lens and then configure the camera
settings.
Note: Before installing, please ensure that the mounting surface is strong enough
to withstand three times the weight of the camera. If the mounting surface is not
strong enough, the camera may fall and cause serious damage.
Mount the camera
1. When installing the TVB-2104/TVB-4104 and TVB-2105/TVB4105 camera,
please use the attached mount
2. Using the mount as a template, place it level against the mounting surface
and mark the position of the mounting holes.
3. Following all local codes, drill and prepare the mounting holes.
4. Securely fasten the mount to the mounting surface with the appropriate
fasteners.