Casio XJ-M145 - Manual (Page 13)

E-11
Getting Ready
Important! Important! Important!
z Be sure to use alkaline batteries only.
Replacing Remote Controller Batteries
Open the battery cover on the back of the remote controller, replace the old batteries with new ones, and
then close the battery cover.
Important! Important! Important!
z To avoid running down the batteries, store the remote control unit so its buttons are not
pressed inadvertently.
Locate the projector on a desk, table, or stand that is firm and level. Make sure to allow sufficient space
around the sides and back of the projector for proper ventilation. The following illustrations show how the
projector should be oriented for optimum projection relative to the screen.
z The projector can be configured for projection from the back of a screen. For details, see the User’s
Guide on the CD-ROM that comes with the projector.
Loading Remote Controller Batteries
*
Caution
RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE.
DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS.
1. Open the battery cover on the back of
the remote controller. 2. Load two new batteries into the case,
making sure that their positive (+) and
negative (–) ends are facing correctly.
3. Close the battery cover on the back of the remote controller.
Setting Up the Projector
XJ-M140/XJ-M145/XJ-M150/XJ-M155 XJ-M240/XJ-M245/XJ-M250/XJ-M255
Make sure the projector is at a right angle to the screen. Position the projector so the lens side is at the edge of the
table, etc.
Screen Screen