Interlogix NX-148E - Manual (Page 13)

NX-148E LCD Keypad 11
VIEW ZONE STATUS
Step 1 Press r • . The LCD Screen will display the zone status.
Step 2 Use the up and down scroll keys to browse through the descriptions. The LCD
Screen will display the list of all zones in sequential order by zone number.
Step 3 Press [#] to exit this function.
SETTING THE KEYPAD TONE
Step 1 Press r 0 . Keypad is now in the “Adjust Tone” mode.
Step 2 Press the • up scroll key located on
the right side of the display to adjust
the keypad sounder to higher tones.
Step 3 Press the – down scroll key to adjust
the keypad sounder to lower tones.
Step 4 When the desired tone is reached, press # to set this tone and exit from the
“Adjust Tone” mode.
VIEW ALARM MEMORY
Step 1 Press r 3 to display the zone(s) on the keypad that created the last
alarm.
Step 2 The LCD Screen will display the zone
description for those zones.
Step 3 Press [#] to exit the alarm memory.
TEST FUNCTION (Optional, if programmed)
If programmed, this function will perform a battery test, communicator test, and/or a
siren test. No alarms will be sent, and no reports will be sent unless a communicator
test is performed, in which case a test signal will be sent.
Step 1 Press r 4 4 . The test will be performed as programmed.
Step 2 If the siren test is performed, enter a user code to silence the siren.
Raise tone
º
Lower tone º
A l arm Memory 1
ZONE 1