ISP Technologies XMAX112 - Manual (Page 5)

5
REAR PANEL DESCRIPTION
1.
LEFT HIGH PASS BALANCED OUTPUT- This XLR male connector provides a
balanced high pass output from the left channel input. The high pass frequency
is set at 100 Hz with a 24 dB per octave roll off.
2.
RIGHT HIGH PASS BALANCED OUTPUT- This XLR male connector provides
a balanced high pass output from the right channel input. The high pass
frequency is set at 100 Hz with a 24 dB per octave roll off.
3.
LEFT FULL RANGE BALANCED OUTPUT- This XLR male connector provides
a balanced full range output from the left channel input. This connector may
used to daisy chain the full range signal to additional powered sub cabinets
such as another XMAX112 or SA115.
4.
RIGHT FULL RANGE BALANCED OUTPUT-- This XLR male connector
provides a balanced full range output from the right channel input. This
connector may used to daisy chain the full range signal to additional powered
sub cabinets such as another SA 118 or SA115.
5.
INPUT/PHASE SWITCH- This switch will function to bypass the internal
crossover feeding the input to the internal power amp of the XMAX212
subwoofer. On other models, this will control the phase of the input signal
feeding the internal amplifier but is configured to by pass the crossover for the
XMAX112 subwoofer. This will allow the use of an external crossover to
configure the system. This switch will not affect any of the balanced outputs.
6.
INPUT SENSITIVITY- This control determines the overall input level of the
signal to the power amp section of the subwoofer cabinet. Adjusting this level
will not affect the level of the signal passing through to the full range or the high
pass outputs.
7.
LEFT BALANCED INPUT- This female XLR connector provides an input for the
left channel signal source. This will also feed the left channel signal to the left
high pass and left full range balanced outputs.
8.
RIGHT BALANCED INPUT- This female XLR connector provides an input for
the right channel signal source. This will also feed the right channel signal to
the left high pass and right full range balanced outputs.
9.
EXTENTION SPEAKER OUTPUT- THIS OUTPUT IS NOT FUNCTIONAL ON
THE XMAX112 SUBWOOFER.
10.
POWER SWITCH- This switch provides power to the subwoofer amp section.
Make sure that the input sensitivity control is set to minimum upon power up
11. POWER INLET MODULE- This module provides a connection for the power
cord and also houses the mains fuse.
(See Fuse Replacement Section)