ISP Technologies CS 650 - Manual (Page 7)

Connections to the CS650 Speaker
The CS650 bottom edge of the Printed Circuit Board contains three RJ45 connectors,
providing INPUT, OUTPUT and REMOTE LEVEL connections. Connect the input RJ45
to the output of the HDDS Master Control Module Zone Output A, B or C. Connect the
OUTPUT RJ45 connector to the next CS650 in the serially connected chain of speakers.
If a separate Remote Level control is required connect the LVL (REMOTE LEVEL PORT)
to one of the ISP Technologies Remote Level Controls RM10, RM20 or RM20I. Note:
The CS650 ships with an RJ45 Jumper plug inserted in the Remote Level
Port, This jumper is required for audio to pass if no remote level control is
used. If connecting to a RM20 or RM20I remove this jumper and connect the
desired remote level control.
REMOTE LEVEL CONTROL
SPEAKER POWER:
The HDDS system distributes low voltage Alternating Current over the Cat5 cable plus
high level balanced audio and is capable of greater than 30 watts continuous power per