Power-on self test (post), Running, Presario 1200 series – Compaq XL118-XL127 User Manual
Page 45
P
RESARIO
N
OTEBOOK
M
AINTENANCE
AND
S
ERVICE
G
UIDE
1200XL S
ERIES
T
ROUBLESHOOTING
3
Presario 1200 Series
Models: XL101-XL113, XL115, XL118-XL127
7. To clear the password, remove the RTC battery
1
for 30 seconds and replace it.
8. Reassemble the notebook.
9. Turn on the notebook to verify that the power-on password has been cleared. If it has
not been cleared, repeat Steps 1 through 9.
Power-On Self Test (POST)
To run POST, complete these steps:
Turn off the notebook, then turn it on again. As soon as the Compaq logo appears press the
ESC key to clear the logo and display the POST messages as they occur.
If the notebook does not beep, POST has successfully completed its test and detected no
errors. POST then re-boots from the hard drive, or from a bootable diskette if one is
installed in the diskette drive.
However, if POST detects errors, these are indicated by messages on the display screen
and/or audible messages. A list of the POST error codes and what they mean is shown in
the table below.