Cisco 2600 - Manual (Page 19)

Release Notes for Cisco IOS Release 12.0(7)XK1 Feature Packs for Cisco 2600 Series Routers 19
Alternatives to RSL
The following example shows how to use the copy xmodem flash command on a Cisco 2600 series
router.
Router# copy xmodem flash
**** WARNING ****
x/ymodem is a slow transfer protocol limited to the current speed
settings of the auxiliary/console ports. The use of the auxiliary
port for this download is strongly recommended.
During the course of the download no exec input/output will be
available.
---- ******* ----
Proceed? [confirm] yes
Use crc block checksumming? [confirm] yes
Max Retry Count [10]:
Perform image validation checks? [confirm] yes
Xmodem download using crc checksumming with image validation
Continue? [confirm] yes
Partition Size Used Free Bank-Size State Copy Mode
1 4096K 3259K 836K 4096K Read/Write Direct
2 4096K 0K 4095K 4096K Read/Write Direct
[Type ?<no> for partition directory; ? for full directory; q to abort]
Which partition? [default = 1] 2
System flash directory, partition 2:
File Length Name/status
1 68 TESTFILE
[132 bytes used, 4194172 available, 4194304 total]
Destination file name? c3620-i-mz.0918
Erase flash device before writing? [confirm] yes
Flash contains files. Are you sure you want to erase? [confirm]y
Copy '' from server
as 'c3620-i-mz.0918' into Flash WITH erase? [yes/no] yes
Erasing device... eeeeeeeeeeeeeeee ...erased
Ready to receive file...........C
Verifying checksum... OK (0x5DE8)
Flash device copy took 00:12:06 [hh:mm:ss]
Installing the Router Software Using a TFTP Server Application
Use this TFTP server application method as an alternative to using the RSL to install the router
software from the CD-ROM. You can perform this procedure using a PC (running Microsoft
Windows 95 or Microsoft Windows 3.1), a Macintosh, or a UNIX system. You can use either the
copy tftp flash or copy rcp flash command to download the router software to the router.
First, obtain a TFTP application or a remote copy protocol (rcp) application to set up your computer
as a TFTP server or a rcp server. Only use the RSL or the TFTP server included on the feature pack
CD-ROM to install the router software if you are using a PC running Windows 95. For other
operating systems, a number of TFTP or rcp applications are available from independent software
vendors or available as shareware from public sources on the World Wide Web.