Replacing the router cover, See the – Cisco 3725 User Manual
Page 16
16
Installing AC Power Supplies in Cisco 3725 Routers
78-13820-01
Replacing the Cisco 3725 Power Supply
Replacing the Router Cover
After you finish replacing the power supply, follow these steps to replace the cover:
Step 1
Place the chassis bottom so the front panel is closest to you.
Step 2
Hold the cover so the tabs at the rear of the cover are aligned with the chassis bottom.
Step 3
Push the cover toward the rear, making sure that the cover tabs fit under the chassis back panel, and the
back panel tabs fit under the cover.
Step 4
Slide the cover slightly to the left to lock the cover into position (number 1 in
).
Figure 10
Replacing the Cisco 3725 Router Cover
Step 5
Lower the front of the cover onto the chassis (number 2 in
).
Step 6
Fasten the cover with the five screws you set aside earlier.
Step 7
Reinstall the chassis on a rack.
Step 8
Reinstall network interface cables.
62492
1
2