Castelle 61-1273-001 - Manual (Page 9)

Introducing the FaxPress Xerox Interface
1—5
• The Xerox WorkCentre Pro or Document Centre must be a model
that supports the Xerox Server Fax Kit.
• The FaxPress server must be configured in compliance with the
requirements of your local telephone service provider.
• The FaxPress Xerox Interface workstation must be running one of
the following operating systems: Windows NT 4.0 Workstation or
Server, Windows 2000 Pro or server, Windows 2003 Server, or
Windows XP; it must have a Pentium III 500 MHz CPU or faster
(or equivalent CPU), 256 MB of RAM and at least 256 MB of free
space on its hard drive. The FaxPress Xerox Interface will perform
best if this workstation is dedicated, but it will run on any
workstation or server that meets the above requirements.
• You must have a local area network (Windows NT or Novell) to
which you can connect your FaxPress server, the Windows
workstation on which the interface will run, and the Xerox
WorkCentre Pro.
See the FaxPress and Xerox Administrator Guides for details.
Note: The requirements listed above are for a minimal FaxPress
Xerox Interface; you can connect several Xerox systems to a
FaxPress server, and for high-volume faxing, more than one
FaxPress server can be configured for use with numerous
Xerox systems.
Overview of Installation and Configuration
Procedures
To set up your FaxPress server and Xerox WorkCentre Pro system for the
FaxPress Xerox Interface, complete the following procedures.
1. Connect the FaxPress server hardware and the Xerox WorkCentre
Pro system to the same segment of your LAN.
2. Create a Fax Repository for each Xerox system connected to your
LAN, placing these repositories on the Windows workstation you
plan to use for your FaxPress Xerox Interface (preferably, a dedi-
cated PC).