Philips DVD420AT - Manual (Page 11)

Preparing the Remote Control Operating with the Remote Control
Insert the batteries into the remote control so you can use it to
operate the DVD video player.
Make sure to match the + and - on the
batteries to the marks inside the battery
compartment.
Close the cover.
This section shows you how to use the remote control.
Point the remote control at the
remote sensor and press the buttons.
a
ji.r 1 1
0 ■!. z'
*._ i /
/ 30 ° 30°^
Within about 20 feet
I
Distance: About 20 feet from the front of the
remote sensor
About 30° in each direction of the
front of the remote sensor Angle:
Do not expose the remote sensor of the
DVD video player to a strong light source
such as direct sunlight or illumination. If
you do so, you may not be able to operate
the DVD video player with the remote
control.
• Point the remote control at the remote sensor of the DVD video player.
• Do not drop the remote control.
• Do not leave the remote control near an extremely hot or humid place.
• Do not spill water into or put anything wet on the remote control.
• Do not open the remote control.
Improper use of batteries may cause battery leakage and corrosion. To
operate the remote control correctly, follow the instructions below.
• Do not Insert the batteries into the remote control in the wrong
direction (follow the +/- signs).
• Do not charge, heat, open, or short-circuit the batteries. Do not throw
the batteries into a fire.
• Do not leave dead or exhausted batteries in the remote control.
• Do not use different types of batteries together, or mix old and new
batteries.
• If you do not use the remote control for a long period of time, remove
the batteries to avoid possible damage from battery corrosion.
• If the remote control does not function correctly or if the operating
range becomes reduced, replace all batteries with new ones.
• If battery leakage occurs, wipe the battery liquid from the battery
compartment, then insert new batteries.
Built-in Locator of the Remote Control
The remote control lets you know its location by beeping
each time the main power is turned on.
1 Press the POWER ON / STANDBY button on the front
panel of the DVD video player to turn the DVD video
player on.
The remote control beeps so that you can easily locate it.
The remote control should be within about 20 feet from
the DVD video player, not being obstructed.
2 To turn off the beep, press any button on the remote
control.
• Re-execution requires an interval of about thirty seconds.
• The built-in locator may not work depending on the
condition, (ex. obstructions, direction of the remote control,
etc.)
10