Cobra Electronics MICROTALK PR4800WXC - Manual (Page 10)

Intro Operation Customer
Assistance Warranty
Notice
Main Icons
Secondary Icons
While de-programming a memory location, if you do not press any
buttons for 15 seconds, your radio will automatically return to
Standby mode on the channel/privacy code displayed before you
entered mode functions.
Channel Scan
•
Your microTALK radio can automatically scan channels.
To scan channels:
1. Press the Mode/Lock button until the
Scan icon and the channel numbers
flash on the display.
2. Press the Channel Up or Channel Down
button to begin scanning channels.
The radio ignores specific privacy
codes while scanning channels.
The Scan icon will continue to be displayed
when scan is on. Your radio will continue to
scan all channels and stop if an incoming
transmission is detected. Your radio will
remain on that channel for 10 seconds.
While setting channel scan, if you do not press any buttons for
15 seconds, your radio will automatically return to Standby mode
on the channel or channel/privacy code displayed before you
entered mode functions.
During channel scan (while receiving an incoming transmission),
you can choose from the following:
a. Press and hold the Talk button to communicate on that
channel. Your radio will remain on that channel and return
to Standby mode.
b. Press the Channel Up or Channel Down button to resume
scanning channels.
If you press the Talk button while scanning, but more than
10 seconds after receiving a transmission, you will transmit
on the channel on which you last received a transmission.
This will return the radio to Standby mode.
Intro Operation Customer
Assistance Warranty
Notice
Main Icons
Secondary Icons
Intro Operation Customer
Assistance Warranty
Notice
Secondary Icons
Customer Assistance Warranty Introduction
15 Nothing Comes Close to a Cobra ®
Operation
Intro Operation Customer
Assistance Warranty
Notice
Secondary Icons
14 English
Mode Functions
3. Press the Talk button to return to Standby
mode on the selected memory location.
A memory location can be reprogrammed
at any time it is displayed. Press the
Enter/Hi•Low button to begin.
While recalling a stored memory location, if you do not press any
buttons for 15 seconds, your radio will automatically return to
Standby mode on the channel/privacy code displayed before you
entered mode functions.
To de-program a memory location:
1. Press the Mode/Lock button until the
Memory icon and the memory location
flash on the display.
2. Press the Channel Up or Channel Down
button to select the memory location
(0 through 9).
If a location has been programmed
before, its associated channel/privacy
code will be shown on the display.
3. Press the Enter/Hi•Low button. The channel
numbers will flash on the display.
4. Press the Channel Up or Channel Down
button to select Channel 0.
5. Choose one of the following:
a. Press the Enter/Hi•Low button to enter
the channel/privacy code in the selected
memory location and return to the
beginning of memory location options.
b. Press the Mode/Lock button to
enter the channel/privacy code in
the selected memory location and
proceed to other functions on the
channel/privacy code displayed
before you entered mode functions.
Operation
Intro Operation Customer
Assistance Warranty
Notice
Secondary Icons
Scanning Channels
Channel Buttons
Mode/Lock Button
Channel Buttons
Memory Icon
Enter/Hi-Low Button
Channel 0
Channel Buttons
Mode/Lock Button