Cardo Q2 - Manual (Page 4)

Wall Charger
Allen Wrench
Velcro Pads
MP3 Cable
MP3 Cable Holder
Glue Plate
Pre-moistened Towelette
Carry-Pouch
Microphone Sponges
Flat sponge for full-face helmets and round sponge for other helmet types
User Guide, including Warranty and Registration form
IMPORTANT:
The scala rider Q2 is a water-resistant device, designed for use under
moderate rain or snow conditions. However, the headset is not
waterproof and should not be used under severe weather conditions.
The cover tongue protecting the Charging Jack should be kept tightly
closed at all times to prevent moisture from entering the device.
BEFORE USING (CHARGING THE
HEADSET)
Make sure that the headset is fully charged for at least five hours
before initial use.
1. Connect the wall charger to the headset’s Charging Jack (located
between the two Volume Buttons).
2. While charging, the Red Light turns on (it may take up to 15
seconds until the Red Light turns on). When charging is complete, the
Red Light will turn off.
SET UP AND CONFIGURATION
STEP 1
SET UP FOR BIKE-TO-BIKE INTERCOM: PAIRING
The scala rider Q2 can be paired with up to two other headsets for
Intercom communication, referred to in this guide as:
Primary Buddy
and
Secondary Buddy
Pairing is a one time process. Once the headsets are paired during
this Setup Procedure, they will remain paired and automatically
recognize each other whenever they are within range.
scala rider Q2 or other
scala rider headset
Bike-to-Bike Intercom
up to 500 m / 540 yd
(in open terrain)
Mobile phone
Driver-to-Passenger
Full-duplex
Intercom
Connection
Built-in
FM radio
GPS
MP3
player
4 scala rider ® Q2 ™