Philips G380-60 - Manual (Page 7)

Beard Trimming Without
AccuControl Comb
Remove comb if you are:
► Defining hair lines
I Trimming nape of neck
I Removing single, unwanted hairs
D
Be certain the Groomer is in the OFF
position.
a Remove the AccuControl comb attachment
by pressing and sliding the Hair Length
Selector upwards (fig. 7).
Never pull off the AccuControl comb attachment
by grasping the flexible top portion. Always pull off
by the bottom part of attachment.
u Switch the Groomer ON.
□ Make well-controlled movements.Touch the
hair/skin lightly with the Groomer.
Defining Beard, Moustache and
Sideburns
n Be certain the Groomer is in the OFF
position.
B Remove the AccuControl comb attachment
by pressing and sliding the Hair Length
Selector upwards (fig. 7).
B Detach the full width trimmer attachment by
pushing the release button (fig. 8).
□ Put the precision trimmer attachment on the
Groomer (fig. 9).You will hear a click.
I Hold the Groomer upright when you use the
precision trimmer attachment (fig. 10).
Using Nose, Ear & Eyebrow
Trimmer Attachment
H
Be certain the Groomer is in the OFF
position.
B
To attach or remove nose, ear, eyebrow
trimmer (or change attachments):
► Remove the AccuControl comb attachment
(fig-7).
I Remove the full width trimmer attachment by
pushing the release button (fig. 8).
I Put the nose, ear, eyebrow attachment on the
Groomer (fig. I l).You will hear a click.
Trimming Nose Hair
I Make sure nasal passages are clean.
o Place nose, ear and eyebrow attachment on
Groomer.
B
Switch the Groomer on and insert the tip of
the attachment into one nostril (fig. 12).
CAUTION: Do Not insert the tip more
than 3/16 in./Smm into your nostril.
B
Slowly move the tip in and out while
turning it around at the same time in order
to remove unwanted hair. For best results,
make sure the side of the tip is firm against
skin.This will reduce the tickling effect that
can occur during trimming of nose hair.
□ Turn off Groomer. Rinse attachment clean
after each use.