Coleman 9987 Series - Manual (Page 13)

English-12
Care, Maintenance
and Cleaning
Suggested Cleaning Materials:
• Mild dishwashing liquid detergent
• Hot water
• Nylon cleaning pad
• Soft, dry cloth
Component Cleaning:
■ Make sure rotisserie is sufficiently cool.
■ COOKING SURFACES: Wash the food
contact surfaces with hot soapy water. These
items include the rotisserie spit rod and meat
forks. Remove stubborn residue with a mild
cleanser and a nylon cleaning pad. DO
NOT use a commercial oven cleaner. Wipe
dry with a soft, dry cloth.
■ EXTERIOR SURFACES: Clean exterior
surfaces with mild soap and hot water.
Remove stubborn residue with a mild
cleanser and a nylon cleaning pad. DO
NOT use abrasive cleaners. Wipe dry with
a soft, dry cloth.
Igniter service:
The igniter for the rotisserie is a standard
piezo igniter. It does not require a battery.
See the parts list for replacement items for
your rotisserie.
Preventive maintenance:
Light and burn the infrared burner at least
once a month to ensure there is not a build-
up of debris or grease on the burner. This will
ensure the ceramic burner will continue to
operate as it should.
REPRESENTATIVE
ILLUSTRATION
Note:
Spiders and small insects can spin webs and
build nests inside the burner tube. This
especially occurs in late summer and fall
before frost when spiders are most active.
These nests can obstruct gas flow and cause
a fire in and around the burner valve. Such a
fire can cause operator injury and serious
damage to the rotisserie. To ensure full heat
output, inspect the burner tube often (once or
twice a month).
If your unit shows indications of insect webs
or nests, contact your nearest service center
or call Coleman for assistance. Figure 26
shows the areas for a service center to
inspect.
NOTE: Water or air pressure will not normally
clear a spider web.
Cleaning the Burner:
WARNING
Spider’s nests or wasp’s mud inside the
burner tube may cause fire at the valve. If a
fire occurs, immediately turn off the gas
supply at the L.P. cylinder valve (see
representative illustration in Fig. 25).
Fig. 25
CAUTION
All cleaning and maintenance should be
done only when the rotisserie and grill
are cool and with the fuel supply turned
off at the cylinder.
Orifice Fitting
Infra Red Burner
Venturi
Fig. 26