Cobra Electronics FRS 225 - Manual (Page 6)

2 The TX/RX indicator
will be displayed.
Operation
7
Note
While the TALK button is
depressed you cannot
receive incoming calls.
Note
Both units must be ON and
tuned to the same channel.
Your incoming “Call” signal
volume is dependent on the
unit volume setting.
Roger Beep
Confirmation
Tone
Listening For
Another Party
Operation
6
Calling Another Party
To alert another party that you wish to
communicate:
Talking To Another Party
Push and release CALL button. The unit
you are calling will hear a two second ringing
tone.
Roger Beep Confirmation Tone Calling
Another
Party
Note
While the TALK button is
depressed you cannot
receive incoming calls.
Talking To
Another Party
call call
1
3 4
call
BATT LOW
lock mode
1
BATT LOW
call
Release TALK
button and listen for
response.
Hold mic about 2 inches
from mouth. Speak in a
normal voice.
Push and hold
TALK button.
Listening For Another Party
When finished talking:
Release TALK button to receive incoming
transmissions.
Your microTALK® is always in listening mode
when the TALK button is not pressed.
Adjust volume by turning the On/Off Volume
Switch
1
Your listener will hear an
audible tone when you
release the TALK button.
This alerts the other party
that you are finished talking
and it’s OK for them to begin
talking.
call
BATT LOW
lock mode
2