Hyundai H-CT20 - Manual (Page 2)

2
Important safeguards
The owner s manual contains important operating and maintenance instructions for your safety. It is necessary to refer the manual.
Do not install the tweeter where it may be subjected to excessive heat moisture, dust or where they it be kicked repeatedly, brushed or bumped.
Before mounting and connecting the wires be sure that wire of the negative pole terminal is disconnected from accumulator. Nonobservance of this
demand may cause the short circuit or fire.
To prevent short circuit never put or leave any metal objects (e.g. coins or metal tools) inside the tweeter.
Make absolutely sure that the terminals for the tweeters are connected to the proper outputs from the music source.
Never run the wiring on the outside of the vehicle or under it where it can be damaged by road hazards or the moving parts of the vehicle. Use existing
wire channels, sills, panels and molding strips inside the vehicle to hide the wiring for safety and a neat appliance.
Make sure the wire of the negative pole terminal is disconnected from accumulator while connecting the tweeter terminals. Turn on the various
components and slowly advance the volume. Remember to check and re-check all connections to insure proper installation and use.
Do not continuously use the tweeter beyond the nominal power handling capacity.
Keep recorded tapes, watches, and personal credit cards using magnetic coding away from the tweeter to protect them from damage caused by the
magnets in the speakers.
If you cannot find the appropriate mounting location, consult your car dealer or your nearest dealer before mounting.
CAUTION: Take extreme caution when working near the gas tank, gas lines, brake or hydraulic lines and electrical wiring.
Mounting the tweeter
Surface mount tweeter installation (picture 1)
Locate a suitable position for the tweeter. Many positions will provide good sound quality. For optimum staging, position tweeter higher than woofer but
within 5" to 10" of the woofer.
Carefully unscrew the tweeter casing and remove the tweeter.
Using the base of the casing mark the two mounting holes and a hole for passing the wire through.
Cut out these holes.
Pass the tweeter cable through the bottom of the case and into the previously drilled holes.
Securely fix the base of the tweeter in place using the screws.
Select whether the standard casing or the slightly angled casing is to be used and carefully screw the tweeter casing back together, ensuring that no cable
gets trapped.
The tweeter direction should then be adjusted so that the tweeter is focused towards the listener.