CDA SC145 - Manual (Page 3)

GB
ELECTRICAL CONNECTION
The appliances are provided with a three-pole feeding cable and work with alternate cur-
rent and single-phase voltage indicated on the “rating plate of the product “report at the
end of the instruction manual and on the product. The grounding conductor of the cable
is marked with the colours yellow/green.
CONNECTION OF THE FEEDING CABLE TO THE MAINS
Connect the feeding cable of the oven to a plug suitable for the load indicated on the
rating plate of the product. In case of a direct connection to the mains (cable without plug),
it is necessary to insert a suitable omnipolar switch before the appliance, with minimum
opening between contacts of 3 mm (the grounding wire should not be interrupted by the
switch).
Before connecting to the mains, make sure that:
• the electrical counter, the safety valve, the feeding line and the socket are adequate to
withstand the maximum load required (see rating plate).
• the supply system is regularly grounded, according to the regulations in force.
• the socket or the omnipolar switch can easily be reached after the installation of the
oven
• after carrying out the connection to the mains,
check that the supplying cable does not
come into contact with parts subject to heating.
• never use reductions, shunts, adaptors which can cause
overheating or burning.
connection operations are carried out by qualified personnel complying with the
NOTES FOR THE INSTALLATION
local and general regulations in force.
installation or connection. It is therefore necessary that all installation and
The manufacturer is not liable for any direct or indirect damage caused by faulty
This appliance complies with EEC Specification:
- 73/23 + 93/68 (low voltage equipment)
- 89/336 (electromagnetic compability)
- 89/109 ( components coming in conctact with foodstuffs)
- 2002/96 ( WEEE)
18