Casablanca Fan Company Sienna Owner's Manual PSG73M - Manual (Page 11)

11
S S S S S
IE IE IE IE IENA NA NA NA NA
™ ™ ™ ™ ™
Send Signal
LED
Fan Control
To start the fan. Press the selected speed button to run the fan at the desired speed.
LOW=Low speed MED=Medium speed HIGH=High speed
To turn off the fan, press the FAN OFF button.
Airflow Direction
To reverse the airflow, press the REVERSE button. REVERSE operates at any speed
whether the fan is on or off. The fan returns to its set speed after reversing.
Light Control
Turn the light on or off independently from the fan by pressing the LIGHT rocker
switch. (Press the left side for the uplight, right side for the downlight, and the middle for
both.) If you press the button for more than 0.7 seconds, it becomes a dimmer. The light
varies from “bright" to “dim” over approximately 8 seconds. If you continue to hold the
LIGHT button, this sequence will reverse when the light reaches its brightest or dimmest
level. Release the button when the desired level is reached.
Auto Resume
Quick (pressing less than 0.7 seconds) on/off operation of the LIGHT button maintains
the desired brightness level set previously.
If the fan is not functioning after installation:
Step 1. Check to make sure the batteries are installed correctly in
the control.
Step 2. Turn the power off to the fan (from the circuit breaker)
for at least 5 seconds.
Step 3. Turn the power back on (at the circuit breaker) and push
the HIGH, MED, and LOW buttons–in that order–within 20
seconds. The fan should now function properly.
CHANGING TRANSMITTER FREQUENCY SETTING
You will only have to change the dip switch settings in the remote
if you are using more than one fan in the same area and want to
control them separately.
Step 1. At the circuit breaker or fuse box, turn the power off for
the fan you want to change.
Step 2. Open the battery door of the Versa•Touch control and
remove the batteries.
Step 3. Change the dip switch settings, assuring that they are
different from the previously installed Versa•Touch fan.
Step 4. Reinstall the batteries and the battery door on the control.
Step 5. At the circuit breaker or fuse box, turn the power back on
for the fan whose frequency you are changing.
Step 6. Within 20 seconds of restoring power, push the HIGH,
MED, and LOW buttons (in that order).
Circuit Breaker
or Fuse Box
Press in this order to set new
frequency:
1. HIGH 2. MED 3. LOW
Dip Switch
set to “01001”
Dip Switch
set to “10000”
Versa•Touch 2
Control
(back)
LOW
MED
HIGH
DOWNLIGHT
FAN
OFF REVERSE
1
2
3
Note: You may want to label your controls to assure you do not
mix them up.
REMOTE OPERATION
WARNING!
Do not turn the power off at the circuit breaker,
then back on, for the previousl y installed
Versa•Touch2 fan(s), as you may inadvertently
change the frequency settings for it as well.
Note: All fans leave the factory set to “00000.”
UPLIGHT