Chamberlain 3585 3/4 HP - Manual (Page 28)

28
Using the Remote Control
NOTE: To activate the remote control functions, pull out
the plastic pull tab protruding from the remote control
housing.
This remote control is equipped with a proximity lighting
feature. When moving a hand within close proximity to
the remote control, the LED lights turn on for 3 seconds.
Upon successful activation of a remote control button,
the LED lights will blink rapidly.
Proximity Disable Feature
The remote control will turn off the proximity lighting
feature if the proximity lighting is turned on 10
consecutive times without activation of a button. To re-
enable the proximity lighting, simply press a button. This
function conserves battery life.
To Control the Opener Lights
With 315MHz Security ✚ ® remote controls, a remote push
button can be programmed to operate the opener lights
without opening the door.
1. With the door closed, press and hold the remote
button that you want to control the light.
2. Press and hold the Light button on the multi-function
control panel.
3. Press and hold the Lock button on the multi-function
control panel.
4. After the opener lights flash, release all buttons.
Test by pressing the remote push button. The opener
lights should turn on or off but the door should not move.
Open/Close/Stop Operation
Your 315MHz Security
✚
® remote control can be
programmed to operate one door using all 3 buttons: the
button with one light slot will only open the door, the
button with two light slots will close the door, and the
button with three light slots will stop the door’s
movement. You may set up this feature as follows:
1. With the door closed, press
and hold the button with
one light slot.
2. Press and hold the Lock
button on the multi-function
control panel.
3. Press and hold the main door control push button.
When the opener lights flash, release all buttons. Test by
pressing the 1 light slot button (Open) on the remote.
The door should open. Press it again while the door is
open and nothing should happen. Press the 2 light slot
button (Close) while the door is moving and it should
close. Press the 3 light slot button (Stop) and the door
should stop immediately.
1 Light Slot
(Open)
2 Light Slots
(Close)
3 Light Slots
(Stop)
Troubleshooting
Reduced proximity
sensing (does not
activate by
touching top of
remote control)
Check if proximity lighting is
disabled by pressing a button.
Replace 3V2450 battery with
same type 3V2450 coin cell.
The Proximity Sensor may be
oversensitized. Sit remote
control undisturbed for 60
seconds on a non-metallic
surface. This allows the sensor
to recalibrate itself.
Dim LED lights
Replace two 3V2016 batteries
with same type 3V2016 coin
cells.
No rapid LED
blinking after
pressing a button Replace two 3V2016 batteries
with same type 3V2016 coin
cells.
PROBLEM SOLUTION
NOTICE: To comply with FCC and or Industry Canada (IC) rules, adjustment or modifications of
this receiver and/or transmitter are prohibited, except for changing the code setting or replacing
the battery. THERE ARE NO OTHER USER SERVICEABLE PARTS.
Tested to Comply with FCC Standards FOR HOME OR OFFICE USE. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired operation.
The Remote Control Battery
The 3V2016 lithium batteries for the opener and LED
lights (marked “LED and Opener Battery”) should last 5
years. The 3V2450 lithium
battery for the proximity
lighting (marked “Proximity
Battery”) should last 1-2
years. To replace the
batteries, remove the two
screws and open the
remote control housing.
Push the battery out of the
holder for removal. Insert
replacement batteries
positive side up. Dispose
of old batteries properly.
Replace the batteries with only 3V2016 or 3V2450 coin
cell batteries. Use of another cell may present a risk of
fire or explosion.
CAUTION: Do not bend spring contact. If bent the
proximity sensor will not work.
To prevent possible SERIOUS INJURY or DEATH:
• NEVER allow small children near batteries.
• If battery is swallowed, immediately notify doctor.
WARNING
CAUTION WARNING
WARNING
Proximity
Battery
LED and
Opener
Batteries
Spring
Contact