Intex 18 FT X 52 IN ULTRA FRAME POOL 2011 - Manual (Page 7)

118
PO
SAVE THESE INSTRUCTIONS
Page 7
(118PO) ULTRA FRAME POOL ENGLISH 7.5” X 10.3” PANTONE 295U 09/14/2010
English
SETUP INSTRU
C
TIONS
POOL SETUP (continued)
You may have purchased this pool with the Intex Krystal Clear™ filter pump. The pump has
its own separate set of installation instructions. First assemble your pool unit and then set up
the filter pump.
Estimated assembly time 45-60 min. (Note the assembly time is only approximate and
individual assembly experience may vary.)
1. Liner preparation
• Find a flat, level location that is free and clear of stones, branches or other sharp objects
that may puncture the pool liner or cause injury.
• Open the carton containing the liner, joints, legs, etc., very carefully as this carton can be
used to store the pool during the winter
months
or when not in use .
• Take out the ground cloth (7) (optional)
and spread it over the cleared area. Then,
take out the liner (5) and spread it out over
the ground cloth, with the drain valve directed
towards the draining area. Place the drain
valve away from the house. Allow the sun to
warm up the liner before inserting the beams (4) into the sleeve openings.
IMPORTANT: Always set up the pool
unit with at least 2 persons. Do not drag the liner across the ground as this can
cause
liner damage and pool leakage (see drawing 1).
• During the setup of this pool liner, point the hose connections or openings in the
direction of the electric power source. The outer edge of the pool should be within reach
of the pump’s electrical connection.
2. Frame assembly
• The frame pool’s legs (2) and beams (4) fall into two
groups. The smaller diameters are the vertical legs. Both
these legs and beams fit into the T-joints (1).
• Starting at any location, but always working in the
same direction, push the horizontal beam into the
sleeve (see drawing 2.1). Once the beam is centered
take one of the T- joints (1), snap the joint to one end
of the beam by aligning the hole and the spring-loaded
pin. Repeat this procedure in a circular fashion until all
the beams and joints have been connected
(see drawing 2.2).
The last joint connection may be difficult to complete,
but can be easily done by simultaneously raising this
last joint and beam about 2 inches (5 cm), and connect
the beam to the joint while lowering these pieces to
their normal position. The joint will slide into the
beam (see drawing 2.3). Make sure the last joint is
fully assembled before proceeding to assembling the
legs.
5
1
2.1
2.2
1
2.3