Intex WL3110 - Manual (Page 5)

(155PO) POOL LIGHT ENGLISH 7.5” X 9.25” PANTONE 295U 04/28/2013
English
SAVE THESE INSTRUCTIONS
155
PO
Page 5
SETUP INSTRUCTIONS
This product is specially designed for above ground pool. The LED pool-wall light uses magnetic technology
to create a light system that safety generates low voltage current through the pool’s sidewall to a powerful
LED light inside the pool.
IMPORTANT
• This product is for use with above ground non-steel wall pools with a thickness of 1mm
(0.04 in) or less.
• Do not use this product as a free standing light.
1. Separate the pool light (1) from the transmitter (2) by hand through the side opening groove. See
drawings (1 & 2).
CAUTION: To avoid finger pinch or injury, always separate the pool light from the transmitter through
the side opening groove.
2. Place the transmitter (2) on the outside of the pool wall and the pool light (1) on the inside of the pool
wall submerged in water. Ensure the transmitter magnetic poles are properly aligned with the magnetic
poles on the pool light unit. See drawing (3).
3. Adjust the position of the pool light by manually sliding the transmitter position sideways and/or
vertically.
4. Plug the assembled unit to an electrical outlet protected by a ground-fault circuit inter rupter (GFCI).
1 2
WARNING
• Always unplug this product from the electrical outlet before removing, cleaning, servicing or
making any adjustment to the product.
• Do not operate the product if transmitter housing or pool light lens is cracked or showing
water leakage; remove from pool or water immediately.
• Never place the power transmitter in water.
3