Intex Pool Ladder Barrier 20125 - Manual

136
(136) LADDER BARRIER ENGLISH 7.5” X 10.3” 09/07/2009
SAVE THESE INSTRUCTIONS
Page 1
136*-R0-1009
INTEX ® OWNER'S MANUAL
The ladder barrier is designed to close the space between the ladder and the inside wall of the pool, for prevention of
swimming and entrapment behind the ladder or between the ladder steps. Install the barrier to your ladder according to the
following instructions. Make sure to follow the instructions closely and pay attention to all warnings to assure proper
assembly, function and safe use of the ladder and barrier.
• Assembly and disassembly by adults only. Mount barrier only to a fully assembled ladder.
• Avoid entrapment hazard. Make sure the barrier and the ladder are always in the proper position during
use, allowing them to function properly.
• Do not tamper with the barrier and do not allow children to tamper or interact with it. Check and ensure that
all parts are connected and tightened properly before each use.
• The barrier does not replace competent adult supervision. Supervise children at all times, including when
they are using the ladder to enter or exit the pool.
• Use the ladder and the barrier only as intended. Never use for any other purposes. Closely follow all
instructions and warnings on the ladder.
• When not in use remove and secure the ladder away from the pool to prevent unauthorized or
unsupervised pool entry.
FAILURE TO FOLLOW THESE WARNINGS MAY RESULT IN DROWNING BY ENTRAPMENT, OTHER
SERIOUS INJURY OR DEATH.
WARNING
3
REF. NO.
DESCRIPTION
SPARE
PART
NO.
LADDER SIZE & QUANTITY
FRAME
POOL
EASY
SET®
POOL
RECTAN-
GULAR
POOL
COMMON
PARTS
36” 42” 48” 52”
58976E 58977E 58978E 10903E 58979E 10904E
1 CLAMP 11189 2 2 3 3 3 3
2
SMALL BARRIER FOR FRAME POOL 11180 1 1
LARGE BARRIER FOR FRAME POOL 11182 1 1 1 1
3
SMALL BARRIER FOR EASY SET POOL 11181 1 1
LARGE BARRIER FOR EASY SET POOL 11183 1 1 1 1
4 BARRIER FOR RECTANGULAR FRAME POOL 11184 1 1
1 2 4
PARTS LIST
The pool ladder comes packaged with two (2) or three (3) barriers. However, if the ladder was included with your pool, it will
have only one (1) barrier, appropriate for the pool it was supplied with. In case of three barriers, please note that one barrier is
designed to be used with an Intex Round Metal Frame style pool, the second barrier is designed to be used with an Easy Set
®
style pool with an inflatable top ring and the third barrier is to be used with an Intex Rectangular Frame style pool.
Determine which style of pool you have and use only the appropriate barrier unit to completely assemble your pool ladder. For
the assembly you will need one barrier and two (for 36” and 42” ladders) or three (for 48” and 52” ladders) included mounting
clamps.