Jas-Audio ORSUS - Manual (Page 3)

Unpacking Inspection
The tweeter of JAS Orsus speaker is protected with a
Transparent-Protective-Sheet to prevent damaging on
the Tweeter Unit (Dispersion Board + Driver Net)*.
Customers are recommended to remove the
Transparent-Protective-Sheet immediately before
using or installing on your listening system!
Orsus Assemble Kit Setup
Each Orsus Packing Box contains a set of Orsus Assemble Kit, which carry
the feeding parts and accessories. Setup-Procedure as follow:
1. Two oversized Aluminum-Bar-
feeders need to be installed side by
side (Screws and Tools attached in
kit). Well, Orsus is ready to lunch
after turning up!
2. By turning the level screw (top of the copper-spike), the speaker can
be leveled where it stands. Spike discs use as an option, serve to
protect your flooring from the needle sharp spikes..
Caution:
Do not over tighten the level-
screws when installing the feet. Doing so
might risk breaking the bar feeder holes,
and level-screws become functionless. A
removable warning label has been
attached at the base of each speaker
already.
Page 3 of 7
http://www.jas-audio.com