Jaypro Sports EC-1000 - Manual (Page 2)

REV: B 1/12
JAYPRO SPORTS
VOLLEYBALL STANDARD CARRIER, EC-1000
LIST OF MATERIALS
PIECE NO. DESCRIPTION QTY.
1 SIDE FRAME 2
2 CROSSBAR 4
3 HEX HEAD BOLT M8 x 45mm 8
4 LOCKNUT M8 8
5 PLASTIC TIE 10
6 EQUIPMENT BAG 1
7 J-HOOK COVERS (FACTORY INSTALLED) 12
8
3” x 3” END CAP (FACTORY INSTALLED)
4
9
5” STEM MOUNTED SWIVEL CASTER WHEEL 4
10 M8 FLAT WASHERS 16
ASSEMBLY INSTRUCTIONS
1) POSITION EACH CROSSBAR (2) ONTO THE BASE ASSEMBLY (1)
NIPPLES. DROP THE HEX HEAD BOLTS M8 x 45mm (3) THROUGH THE
MOUNTING HOLES AND TIGHTEN IN PLACE USING LOCK NUTS M8 (4)
& FLAT WASHERS (10).
2) FIRMLY SLIDE EACH STEM CASTER (9) INTO THE SOCKET IN THE
BOTTOM OF EACH SIDE FRAME LEG. THE CASTER MUST BE FULLY
SEATED IN THE SOCKET FOR THE UNIT TO ROLL PROPERLY.
GENTLY ASSEMBLE THE END CAPS (8) INTO THE OPEN TOP OF EACH
SIDE FRAME LEG. USE A RUBBER MALLET OR WOOD BLOCK TO
AVOID DAMAGE TO THE CAP.
3) PLACE EQUIPMENT BAG (6) WITHIN THE ASSEMBLED FRAME AND
LOOSELY FASTEN TO THE FRAME CROSSBARS USING THE PLASTIC
TIES (5) PROVIDED. DO NOT CINCH THE TIES FULLY UNTIL ALL OF
THE TIES HAVE BEEN AFFIXED AND THE BAG IS CENTERED WITHIN
THE FRAME. TIGHTEN TIES AS NEEDED AND CLIP OFF ANY EXCESS
ENDS.