CyberData VoIP Ceiling Speaker - Manual (Page 9)

7
Objectworld Communications Corp. • 308 Legget Drive • Ottawa, ON • Canada • K2K 1Y6 • T: 613-599-9698 • F: 613-599-7457
• www.objectworld.com
3.2 CyberData VoIP Speaker Network Settings
The VoIP Ceiling Speaker is configured with a static IP address on factory default. This must be changed so that the device is
connected to your network.
To enter network settings for CyberData VoIP Paging Amplifier
1. Open your browser and type the IP Address of the speaker. The factory default is 192.168.3.10.
2. When prompted, use the following default Web Access username and password:
•
Web Access Username: admin
•
Web Access Password: admin
3. Click Network Setup.
4. Under IP Addressing, select DHCP.
5. Click Save Settings.
3.3 Determining the IP Address of the speaker
The speaker has an RTFM (Reset Test Function Management) switch that allows you to test or reset the device. This function
also has the capability to announce the IP address. This is useful, for example, when you are using the speaker in a DHCP
network configuration and need to know the IP address.
To determine the IP address of the speaker
1. Press and hold the RTFM switch until it beeps (after one second).
2. Release the switch to hear the IP address announcement.
3.4 Firmware Upgrades
3.4.1 Upgrade Compatibility
Refer to the Technical Note “TN051 – SIP Device Features and Comparisons” (a versioned document located on the
Objectworld web site at
www.objectworld.com/support/documentation ) to determine the most recently supported version of
firmware for the device.
Refer to Cyberdata’s web site ( http://www.cyberdata.net/support/voip/ceiling_speaker_upgrade_compatibility.html ) for
information concerning valid upgrade paths. The factory firmware version can be found on the check‐off list shipped with your
VoIP Ceiling Speaker.
3.4.2 RMA Upgrade Procedure
If you determine that you cannot upgrade the speaker yourself, you must send the unit to CyberData to do the firmware
upgrade. For more information on the RMA upgrade procedure, visit the CyberData RMA support page
(
http://www.cyberdata.net/support/rma.html ).
3.4.3 Performing Firmware Upgrades
If you are running version 3.00, an RMA is not required and newer firmware versions can be downloaded from the CyberData
web site.
CAUTION: If you press and hold the RTFM switch for longer than 20 seconds you will
restore the speaker to the factory default settings.