Compaq P700 - Manual (Page 5)

English 1-3
Part Number: xxxxxx-001 - Writer: JD Poteet by: JD Poteet
Saved date: 07/23/99 4:56 PM - File Name:Andretti
Setting Up the Monitor
To set up the monitor, ensure that the power is turned off to the monitor,
computer system, and other attached devices, then follow these steps:
1. Place the monitor in a convenient, well-ventilated location near
your computer.
2. Connect the monitor signal cable
3 to the 15-pin connector on
the rear panel of the computer and tighten the screws.
✎
Be sure the signal cable aligns with the 15-pin connector. Do
not force the cable onto the connector or you may damage the
signal cable.
3. Connect one end of the monitor power cord
1 to the connector
on the back of the monitor and the other end
2 to an electrical
outlet that is easily accessible and close to the monitor.