Chauvet Laser Level - Manual (Page 9)

MinLaser User Manual 9 August 2011
3. S
ETUP
AC Power
This fixture includes an external power supply which is auto-ranging and runs on 100~240
VAC, 50/60 Hz power. Only use the included power supply! To obtain a replacement power
supply, contact Chauvet®.
To determine the power requirements for a particular fixture, see the label affixed to the
back plate of the fixture or refer to the fixture’s specifications chart. A fixture’s listed current
rating indicates its average current draw under normal conditions.

Always connect the fixture to a switched circuit.

Never connect the fixture to a rheostat (variable resistor) or dimmer circuit, even
if the rheostat or dimmer channel is used only as a 0 to 100% switch.

Always connect the fixture to a circuit with a suitable electrical ground.
Mounting
Orientation
The MiN™ Laser FX/RGX/STAR may be mounted in any position provided there is
adequate room for ventilation.
Rigging
Be sure that the structure can support the weight of the fixture. Please see the Technical
Specifications section of this manual for a detailed weight listing.
Mount the fixture securely. Do this with a screw, nut and bolt, or a hanging clamp.
When rigging, consider routine maintenance. Please see the following notes on
installation.

When aiming the fixtures, you may use the bracket adjustment knob(s). Loosen
the knob(s), adjust to the desired angle, and then tighten the knob(s) by turning
clockwise. Do not use tools for this step, as it may cause damage.
 Use the floor stand to support the fixture in a sitting position.
Refer to the diagrams on the next page.
Power Supply