Casio EX-H30 - Manual (Page 133)

133
Using the Camera with a Computer
.
To connect the camera to your computer and save files
1.
Turn on the camera and press [MENU].
2.
On the “Set Up” tab, select “USB” and then press [6].
3.
Use [8] and [2] to select “Mass Storage”, and then press [SET].
4.
Turn off the camera and
then use the USB cable
that comes with the
camera to connect it to
your Macintosh.
• The camera does not
draw power over the
USB cable. Check the
battery level before
connecting and make
sure it is not too low.
• Make sure that you
insert the cable
connector into the USB/
AV port until you feel it
click securely into place.
Failure to insert the
connector fully can result
in poor communication
or malfunction.
• Note that even while the
connector is fully inserted, you still will be able to see the metal part of the
connector as shown in the illustration.
• When connecting the USB cable to a USB port, make
sure you align the connector correctly with the port.
• Your computer may not be able to recognize the camera
if you connect via a USB hub. Always connect directly to
the computer’s USB port.
5.
Turn on the camera.
The camera’s back lamp will light green at this time. In this mode, your Macintosh
recognizes the memory card loaded in the camera (or the camera’s built-in
memory if it does not have a memory card loaded) as a drive. The appearance of
the drive icon depends on the Mac OS version you are using.
USB port
USB cable
(included with camera)
Making sure that the 6 mark on the camera is aligned
with the 4 mark of the USB cable connector, connect
the cable to the camera.
[USB/AV]
port
Large connector
Small connector