Keurig Cuisinart SS-700 - Manual (Page 9)

9
8. Making sure your mug is in place, press
the Brew button to start a cleansing
cycle (unit will dispense approximately
8 oz. of water). The control panel will
display BREWING, as well as the factory
default brew size (see figure 5). When
cycle is complete, dispose of the hot
water.
Note: Do not use a K-Cup ® for this
cycle.
The one-time set-up
process is complete.
Charcoal Water Filter
Your coffeemaker comes with a charcoal
water filter that eliminates chlorine, bad
tastes and odors from tap water.
Inserting the Water Filter
1. Remove the filter and filter holder from
the polybags.
2. Soak the filter, fully immersed in cold tap
water, for 15 minutes.
3. Remove lower portion of filter holder by
pressing the tabs on the sides and
pulling apart. Rinse with fresh water.
4. Insert the charcoal filter into the upper
filter holder, then attach the lower
portion by pressing on tabs and pushing
until it locks into place (see figure 6).
5. Flush filter by running fresh water
through lower portion of the filter
holder.
6. Allow the filter to drain completely.
7. Place the assembled water filter
holder into the water reservoir,
pushing it down to fit into place (see
figure 7).
Note: We recommend changing the
water filter every 60 days or after 60 uses,
and more often if you have hard water.
Replacement filters can be purchased in
stores, by calling Cuisinart Customer
Service, or at www.cuisinart.com.
figure 5
figure 6
Upper Filter Holder
Charcoal Water Filter
Lower Filter Holder
PRESS TABS
figure 7
Water Reservoir Lid
assembled
Charcoal
Water Filter
Water
Reservoir